Axis Q6032-E PTZ Installation Guide download pdf (Page 9)

AXIS Q6032-E/Q6034-E/Q6035-E Installation Guide Page 9

ENGLISH

Install the network camera

1. Install the selected bracket (not included)

according to the instructions supplied with the

bracket. If drilling is required, make sure to use

drill bits, screws, and plugs that are appropriate

for the material. See www.axis.com for infor-

mation on available mounting accessories.

2. Remove the protection cap covering the

network connector on the camera.

3. Route the network cable and attach the

supplied RJ45 connector. Refer to the

instructions provided with the connector for

information on wiring and assembly.

4. Hook the camera to the safety wire on the bracket.

5. Connect the network cable and RJ45 connector to the network connector on the camera.

6. Install AXIS T8124, see

Install AXIS T8124 High PoE Midspan 1-port,

on page 10.

7. Check that the indicator LEDs on the midspan indicate the correct conditions, see the table on

page 11 for further details.

8. Slide the unit holders on the camera into the slots on the bracket and rotate the camera unit.

9. Secure the network camera to the mounting bracket by fastening the 3 screws (Torx T30).

IMPORTANT!

The supplied RJ45 connector or a compatible, IP66 rated RJ45 connector must be used in order to

comply with the IP66 rated design of the camera.

Wall bracket (mounting example, bracket not included)

Safety

wire

Slots for

Screws

Torx T30

unit holders

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 93 94

No comments

Axis Q6032-E PTZ Installation Guide Page 9