Axis Q7414 Installation Guide download pdf (Page 18)

Page 18 AXIS Q7414 Installation Guide

Resetting to the Factory Default Settings

This will reset all the parameters (including the IP address) in all 4

channels to the factory default settings.

1. Press both the Reset button and Control button.

2. Release the Reset button and hold the Control button.

3. Keep the Control button pressed until the Power indicator

turns green and the 4 Status indicators turn amber (this may

take up to 15 seconds).

4. Release the Control button. When the Status indicators

display green (which can take up to 1 minute) the process is

complete and the video encoder has been reset.

5. Re-assign the IP addresses, using one of the methods

described in this document.

To reset a single channel to the original factory default settings,

use the button provided in that unit’s web interface. For more

information, see the online help.

Accessing the AXIS Q7414 from the Internet

Once installed, your AXIS Q7414 is accessible on your local network (LAN). To access the video

encoder from the Internet, network routers must be configured to allow incoming traffic, which is

usually done on a specific port.

• HTTP port (default port 80) for viewing and configuration

• RTSP port (default port 554) for viewing H.264 video streams

Refer to the documentation for your router for further instructions. For more information on this

and other topics, visit the Axis Support Web at www.axis.com/techsup

Further information

The user’s manual is available from the Axis Web site at www.axis.com or from the Axis Network

Video Product CD supplied with this product.

Control button

Power Indicator

Reset button

Status

Indicators 1-4

Tip!

Visit www.axis.com/techsup to check if there is updated firmware available for your

product. To see the currently installed firmware version, go to Setup > About.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 89 90

No comments

Axis Q7414 Installation Guide Page 18