LCD MODULE SPECIFICATION Model : MI12864J-G-1 Revision 1.0 Engineering Date
RELIABILITY TEST CONDITIONS No. Test Item Test Condition Inspection after test 1 High Temperature Storage 802/200 hours 2 Low Temperat
INSPECTION CRITERION This specification is made to be used as the standard acceptance/rejection criteria for Normal LCM Product. 1 Sample plan S
4.Inspection Standard 4.1 Major Defect 4.1.1 All functional defects 1) No display 2) Display abnormally 3) Missing verticalhorizontal segment
9 Solder ball/Solder splash a. The spacing between solder ball and the conductor or solder pad h ≥0.13mm. The diameter of solder ball d ≤0.15mm.
4.2.3 Cosmetic Criteria (Operating) No. Defect Judgment Criterion Partition 1 Spots A) Clear Note : Including pin holes and def
3 Rubbing line Not to be noticeable. Minor 4 Allowable density Above defects should be separated more than 10mm each other. Minor 5 Rainbow Not
PRECAUTIONS FOR USING LCD MODULES 1 Handing Precautions 1.1 The display panel is made of glass and polarizer. As glass is fragile. It tends to
and other work under dry conditions. To reduce the generation of static electricity be careful that the air in the work is not too dry. A relative hu
2 Handling precaution for LCM 2.1 LCM is easy to be damaged. Please note below and be careful for handling. 2.2 Correct handling:
3 Storage Precautions 3.1 When storing the LCD modules, the following precaution are necessary. 3.1.1 Store them in a sealed polyethylene bag. If
REVISION RECORD REV NO. REV DATE CONTENTS REMARKS 1.0 2011-4-15 First release \
4.2 Precaution for assemble the module with BTB connector: Please note the position of the male and female connector position, don’t assemble or ass
4.3 Precaution for soldering the LCM Manual soldering Machine drag soldering Machine press soldering No RoHS Product 290°C ~350°C. Time : 3-
4.6 Limited Warranty Unless agreed between and the customer, will replace or repair any of its LCD modules which are found to be functionally
CONTENTS GENERAL INFORMATION EXTERNAL DIMENSIONS ABSOLUTE MAXIMUM RATINGS ELECTRICAL CHARACTERISTICS TIMING OF POWER SUPPLY BACKLIG
GENERAL INFORMATION Item of general information Contents Unit LCD type FSTN /B/W MODE POSITIVE/TRANSFLECTIVE / Recommended Viewing Directi
EXTERNAL DIMENSIONS LED BACKLIGHT"A"SCAN128X64 DOTS"B"STIFFENERCONTACT SIDEBLACK SILICONE BLACK SILICONEUV tapeFPCDETAL"
ABSOLUTE MAXIMUM RATINGS Parameter of absolute maximum ratings Symbol Min Max Unit Supply voltage for logic VDD -0.3 4.0 V Input voltage VI
ELECTRO-OPTICAL CHARACTERISTICS Item of electro-optical characteristics Symbol Condition Min Typ Max Unit Remark Note Response time Tr+ Tf - 418
FIG.1. The definition of Response Time FIG.2. Measuring method for Contrast ratio,surface luminance, Luminance uniformity,CIE (x, y) chromaticity
INTERFACE DESCRIPTION Pin No. Symbol I/O or connect to Description When not in use 1 NC - No connection - 2 V0 - LCD driver supply voltages.
Comments to this Manuals