Axis M3113-R User Manual download pdf (Page 20)

AXIS M31 Series - Events

Events

• Event Type - A set of parameters describing how and when the AXIS 214 PTZ should perform certain actions. An event

type may result in a single event, or it may result in many, all depending on how often the conditions governing its

behavior are met.

• Triggered Event Type - An event that is activated by a specific internal or external trigger condition; for example by

motion detection or by an external device such as a door switch or a sensor.

• Scheduled Event Type - An event that runs at a pre-programmed time.

• Action - What occurs when the event triggers, e.g. the upload of video images to an FTP server, or email notification.

Event Servers

Event Servers are used to receive uploaded image files and/or notification messages. To set up Event Server connections in

your camera, go to Setup > Events > Event Servers and enter the required information for the required server type.

For details on each setting, see the online help available from each web page.

When the setup is complete, the connection can be tested by clicking the Test button (the connection test takes

approximately 10 seconds).

Event Types

An Event Type describes how and when the camera performs certain actions.

Example: If an event has been configured to detect and respond to motion and somebody passes in front of a camera,

the camera can record and save images to an FTP server, and send a notification to an e-mail address. Images can be sent

as e-mail attachments.

Server type Purpose Information required

FTP Server

• Receives uploaded images • Descriptive name of your choice

• Network address (IP address or host name)

• User Name and Password

HTTP Server

• Receives notification messages

• Receives uploaded images

• Descriptive name of your choice

• URL (IP address or host name)

• User Name and Password

TCP Server

• Receives notification messages • Descriptive name of your choice

• Network address (IP address or host name)

• Port number

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 48 49

No comments

Axis M3113-R User Manual Page 20