Axis Q6032-C Installation Guide Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
AXIS Q6032-E Installation Guide Page 5
ENGLISH
Install the hardware
Before installation
AXIS Q6032-E is supplied with an optional sunshield and smoked transparent dome cover. If
required, follow these instructions to attach the sunshield and replace the dome cover.
Attach the sunshield (optional)
1. Slide the sunshield over the unit holders on the dome camera unit.
2. Secure the sunshield using the supplied screws (Torx T20).
Replace the clear/smoked dome cover (optional)
1. Remove the 4 screws (see illustration on page 4).
2. Remove the metal ring and dome ring from the plastic dome cover.
3. Remove the rubber gasket from the dome cover and attach it to the selected dome cover. Be
sure to attach the gasket so it fits the dome cover perfectly.
4. Attach the metal ring and dome ring and secure by tightening the 4 screws to the maximum
stop.
Note:
Be careful not to scratch or damage the dome cover. Use a soft cloth to wipe clean before
attaching the dome cover to the camera unit.
Install the AXIS Q6032-E
Important!
The supplied RJ45 connector or compatible, IP66 rated RJ45 connector must be used in
order to comply with the IP66 rated design of the camera.
1. Install the selected mounting accessories according to the instructions and remove the protec-
tion cap covering the network connector on the camera.
2. Route the network cable and attach the supplied
RJ45 connector. Refer to the instructions provided
with the connector for information on wiring and
assembly.
3. Hook the dome camera unit to the safety wire on
the bracket.
4. Connect the network cable and RJ45 connector to
the network connector on the dome camera unit.
5. Slide the unit holders on the camera into the slots
on the bracket and rotate the camera unit.
6. Secure the dome camera unit to the mounting
bracket by fastening the 3 screws (Torx T30).
Wall bracket (mounting example)
Safety
wire
Slots for
Screws
Torx T30
unit holders
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 69 70

Comments to this Manuals

No comments