Axis P3367-VE Installation Guide Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 114
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
Page 8 AXIS P33-VE Series Network Camera Installation Guide
Replace clear/smoked dome cover (optional)
The AXIS P3346-VE/P3367-VE/P3384-VE is supplied with an optional dome.
To replace the dome cover:
1. Loosen the 4 screws under the dome cover that hold the dome in place.
2. Replace the old dome with the new and tighten the screws.
Mounting bracket
The mounting plate has 4 mounting hole patterns (A,B,C,D).
The mounting hole patterns follow standard for the following
mounting options:
A: 4" square box
B: standard-sized US double gang junction box
C: 4" octagon box
D: standard-sized US single gang junction box
Route the cables
Depending on whether you want to route the cables through
or along the wall, follow the relevant instructions below.
Routing cables along the wall
1. Using the drill template drill 4 holes in the wall.
2. Attach the mounting bracket to the wall using the 4 screws provided, or screws appropriate for
the wall material.
3. Remove the camera unit from the unit casing by pushing the springs aside.
4. Remove the gaskets from the side holes in the unit casing. If there is only one cable, remove
only one gasket.
5. Place the unit casing on the mounting bracket and attach it by tightening the four screws.
6. Pull the cables up through the side holes in the unit casing.
7. Drag the gaskets along the cable and plug them into the holes. The gaskets should fit snugly in
the holes with no folds or bends.
8. Re-attach the top part of the cable shield by tightening the two screws.
Note:
To avoid moisture-related problems it is recommended that the cables are routed to the camera
from below with the cable holes facing downwards.
Routing cables through the wall
1. Using the drill template drill 4 holes in the wall.
2. Route the network cable (and the I/O, audio cable if necessary) through the wall and through
the holes in the mounting bracket.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 113 114

Comments to this Manuals

No comments