Axis YP3040 Pan-Tilt Motor Installation Guide download pdf (Page 6)

Page 6 YP3040 Installation Guide

Splint dimensions

Connect the cables

1. Connect the power supply to the pan-tilt motor according to the Installation Guide supplied

with the mains adaptor. The recommended mains adaptor is AXIS PS24 Mains Adaptor. For

more information on this product, see the Axis web site at www.axis.com

2. Connect the PTZ control cable to the camera’s RS-485 port. Different camera models have

different terminal connectors, be sure to follow the correct description for the installed camera.

The correct connector is supplied with the Axis network camera. For more information on Axis

network cameras, see the Axis web site at www.axis.com

3. Connect the camera to the network, see the Installation Guide provided with the camera.

Note:

The RJ-45 connector for the network cable will not pass through the cable gland on the

underside of the housing. The cable must be cut, threaded through the cable gland and

then re-crimped.

Wire color Connect to

Power supply cable 24 V AC Red 24 V AC on power supply

Red 24 V AC on power supply

Yellow/green GND

Wire color Connect to

PTZ control cable (RS-485) Red A+ on camera

Blue B- on camera

122 mm (4.8 in.)

Ø 6 mm (0.2 in.)

100 mm (3.9 in.)

70 mm (3.9 in.)

Mounting holes for housing/camera, see Recommended accessories, on page 3

1 2 3 4 5 6 7 8 9 10 11 ... 53 54

No comments

Axis YP3040 Pan-Tilt Motor Installation Guide Page 6