Axis YP3040 Pan-Tilt Motor Installation Guide download pdf (Page 9)

YP3040 Installation Guide Page 9

ENGLISH

About the DIP switch settings

The transmission between the motor and the camera will not work if the camera uses a different

protocol and bit rate than the motor. For cameras with a different protocol than the Pelco-D and

bit rate of 2400 bps, the dip switches must be changed, see Change the DIP switch settings, on page

10.

Note:

The default factory settings of the YP3040 Pan-Tilt Motor are the Pelco-D protocol and a

bit rate of 2400 bps. This means that the DIP switch settings do not need to be changed

when using the motor with an Axis network camera with the Pelco-D protocol.

The YP3040 Pan-Tilt Motor has two sets of 8 digital DIP switches.

The 8 switches on the left-hand side are used to select functions such as protocol, bit rate, and

terminal resistance. The 8 switches on the right-hand side are used to select multiple unique

addresses when connecting several units in a series through a multi-channel video server. There are

255 different switch combinations.

Note:

In a typical installation only the one default address is required.

Select address

Select function

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 53 54

No comments

Axis YP3040 Pan-Tilt Motor Installation Guide Page 9