AXIS 2100 Installation Guide - English Page 5 of 5
Verifying the Modem Connection...
Having initiated your Dial-Up connection as described above, you can quickly check the connection
by accessing the AXIS 2100 from a standard browser; such as Netscape or Internet Explorer, as
follows:
Reinstating the Factory Default Settings
In certain circumstances, it may be necessary to reinstate the Factory Default settings for your AXIS
2100. This is performed by clicking the appropriate button within the Administration Tools, or by
pressing the Control Button. Follow the instructions below to reinstate the product factory default
settings using the Control button:
1.Switch off the AXIS 2100 by disconnecting the power cable.
2. Press and hold the Control Button depressed, and reconnect the power supply cable.
3. Continue to keep the Control Button pressed until the Status Indicator displays yellow (note that
this may take up to 15 seconds), then release the Control Button. When the Status Indicator
displays green (which can take up to 1 minute) the AXIS 2100 will then have been reset to the
original factory default settings.
Note: Reinstating the original default settings causes all parameters (including the IP address) to be
reset.
Focusing Your Camera
If you are unable to view your video images directly from your chosen point of installation, follow
the instructions below to achieve a good basic level of focus for your AXIS 2100:
❶ Since the AXIS 2100 emulates a DNS server, you can type in
any URL (that includes a period) into your browser to display the
AXIS 2100 Home Page, as shown here.
❷ Now, configure the unit using the Installation
Wizard or the Administration Tools.
abc.xyz
❺
Finally, turn the lens slowly clockwise until the
Status Indicator displays Green; that is, until a
Good level of focus (>80%) is achieved.
❼ Return to your browser applica-
tion and check the picture quality.
Repeat step 5 only
if you consider
the focal distance too distant - until
you are satisfied with both the
focal-distance and focus-quality.
1mm max.
❽ To exit the Focus Assistant: press
and hold the Control button until
the Status Indicator flashes Yellow.
The Status Indicator displays Green
when the Focus Assistant is closed.
Fixed Lens Assembly:
NOT
to be adjusted!
Camera Lens
Status Indicator
❶ Power-on the AXIS 2100 and wait 10 seconds.
❸ Enable the Focus Assistant: Press and hold the
Control Button using a thin paper clip or any
other suitably pointed object - until the Status
Indicator flashes Yellow.
❷ Set the AXIS 2100 to its extreme distant-focus
position by turning the Camera Lens fully clock-
wise.
❹ Turn the lens approximately six full-turns in
the anticlockwise direction: Note that unless
you want to replace the lens, it should not
be
unscrewed more than 1mm apart from the Fixed
Lens Assembly.
Control Button
(40 pages)
(76 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals