Axis 5012-014 User Manual download pdf (Page 8)

Page 8 Safety Information

Power Cord Requirements

Power cords must meet the requirements for the country they are used in.

• The Midspan must have access to a power outlet. Disconnect the power

cord from the outlet, to eliminate power from the device.

• The flexible cord that connects to the Midspan must have a configura-

tion to connect with an EN60320/IEC320 inlet connector.

• According to the EN60950/IEC 950 specifications, this device functions

under SELV (Safety Extra Low Voltage) conditions. The conditions are

true if the equipment and the connected device functions under SELV

conditions.

• The AXIS PoE Midspans 8P/16P meet the UL/

cUL per EN60950 safety standard. This is dis-

played in the back side of the product.

USA and Canada • The cord must have a minimum of 10A rated current competence.

• The cord must be CSA or UL approved.

• The minimum requirement for the flexible cord is:

•18 AWG (10A)

• Three-conductor (line, neutral, ground)

• Type SV (Stranded Vacuum Rubber Jacketed) or SJ (Stranded Junior Rubber

Jacketed) or SVT (Stranded Vacuum Rubber Jacketed Themoplastic) or SJT

(Stranded Junior Themoplastic)

• The plug must be earth-grounded with a NEMA 5-15P (15A, 125 V) or

NEMA 6-15P (15A, 250 V) configuration.

Europe and South America Switzerland: The supply plug must comply with SEV/ASE 1011.

Denmark: The supply plug must comply with section 107-2-D1, standard DK2-1a

or DK2-5a.

United Kingdom: The Midspan is covered by General Approval (section 16.16.060),

NS/G/12345/J100003, for indirect connection to a public telecommunication sys-

tem

France and Peru: IT equipment cannot power this device. In the case of an IT pow-

ered device, the unit needs to be powered by 230 V through an isolation trans-

former with a ratio of 1:1 and the secondary connection (Neutral) is properly

grounded.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 53 54

No comments

Axis 5012-014 User Manual Page 8