Axis P3304 User Manual download pdf (Page 9)

AXIS P3304/-V - Accessing the Camera

Note:

• HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between web browsers and

servers. The HTTPS certificate controls the encrypted exchange of information.

• The default administrator user root cannot be deleted.

• If the password for root is lost or forgotten, the network camera must be reset to the factory default settings. See

page 40.

Adjusting the image

Open the Live View page in the web interface and make the

following adjustments on the camera.

1. Loosen the locking screw and tilt adjustment screws.

2. Turn the lens to the desired position.

3. Gently tighten the locking screw and tilt adjustment screws

to secure the camera’s position.

4. Turn the image balance ring to set the horizontal position.

5. Open the Focus Adjustment page in the web interface under

Basic Setup > Focus and follow the on-screen instructions.

Use the image window to adjust the focus and zoom.

To set the focus and zoom, loosen the zoom and focus

pullers counterclockwise and rotate the rings.

Lock the focus and zoom pullers in position by rotating the

screws clockwise.

Note:

Due to the dome's tendency to refract light, the image might appear

slightly out of focus once the dome has been mounted. To compensate, focus on an object slightly closer than the

intended area.

To configure the password

directly via an unencrypted

connection, enter the password here.

To create an HTTPS connection,

start by clicking this button.

Image

Focus puller

Zoom puller

balance

ring

Locking screw

screw

Tilt adjustment

(on each side)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 57 58

No comments

Axis P3304 User Manual Page 9