Axis Q1604 Installation Guide download pdf (Page 14)

Page 14 AXIS Q1602/Q1604 Network Camera Installation Guide

Focus Assistant

To focus your network camera using the Focus Assistant, follow steps 1 - 3 on page 13 before you

start with the steps below.

1. Mount or place the camera so that it cannot be moved.

2. Loosen the zoom puller by turning it counter-clockwise. Move the puller to set the zoom level.

Re-tighten the zoom puller.

3. Set the camera to its extreme distant-focus position by loosening the focus puller and turning

the lens fully clockwise.

4. Press and quickly release the Control button. When the Status LED flashes green, the Focus

Assistant is enabled.

If the Status LED flashes either red or amber before you are able to adjust the lens, skip to step

7 to exit the Focus Assistant and repeat steps 3 - 7. See the notes below.

5. Gently turn the lens counter-clockwise until it stops.

6. Finally, turn the lens slowly clockwise until the status indicator flashes green or amber (not

red).

7. To exit the Focus Assistant, press the Control button again.

Note:

The Focus Assistant is switched off automatically after 15 minutes.

8. Retighten the focus puller.

9. Open the Live View page in the web browser and check the quality of the image.

10. Continue with steps 6 - 8 on page 13.

Notes:

• The view in front of the camera should not be changed during focus adjustment (steps 5 and 6). If the

camera is moved, or if a finger or other object is placed in front of the lens, steps 3 - 7 will have to be

repeated.

• If movements in front of the camera cannot be avoided, the Focus Assistant should not be used.

• If the Control button is not released within two seconds, AXIS Dynamic DNS Service is enabled instead

of the Focus Assistant.

• If the camera is mounted so that the Control button cannot be accessed, you can still use the Focus

Assistant. Follow the instructions above but mount the camera after step 4 (pressing the Control

button) instead and skip step 7.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 103 104

No comments

Axis Q1604 Installation Guide Page 14