Axis Q1604 Installation Guide download pdf (Page 17)

AXIS Q1602/Q1604 Network Camera Installation Guide Page 17

ENGLISH

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet.

CAUTION!

Due to local regulations or the environmental and electrical conditions in which the product is to

be used, a shielded network cable (STP) may be appropriate or required. Network cables that are

routed in outdoor environments or similar shall be shielded (STP) and intended for their specific

use. Make sure that the network switch is properly grounded. See Electromagnetic Compatibility

(EMC) for regulatory requirements

Power connector - 2-pin connector block used for power input.

Audio in - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used

from a stereo signal).

Audio out - Audio output (line level) that can be connected to a public address (PA) system or an

active speaker with a built-in amplifier. A stereo connector must be used for the audio out.

SDHC memory card slot - A standard or high capacity SD memory card can be used for local

recording with removable storage.

To insert an SD card, lift the SD card cover on the rear of the network camera, and carefully insert

the SD card into its slot.

To remove an SD card lift the cover and gently push the card in and release it.

Function Pin number Description

GND 1 Ground

DC Power 2 Power input 8-20 V DC max 10 W

SD memory card slot

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 103 104

No comments

Axis Q1604 Installation Guide Page 17