Axis 850 User Manual download pdf (Page 10)

The newest release for data sheets is available for download at www.pi.ws. 09/05.0

Hexapod Options & Accessories

Photometer card

The F-206.MC6 manual control pad facilitates system setup and

testing procedures. It permits independent motion in all degrees

of freedom with programmable step size

Optical Metrology Boards

The controllers for the F-206,

M-840 and M-850 Hexapod

systems can be

equipped/retrofitted with the

following photometer cards: F-

206.VVU

(2-channel, visual) and

F-206.iiU

(2-channel, IR).

F-206.MC6 6D Interactive

Control Pad Upgrade

The F-206.MC6 manual control

pad facilitates system setup

and testing procedures. It con-

sists of a board that plugs into

the Hexapod controller and a

control pad with six digital

“potentiometer” knobs (one for

each degree of freedom).

The manual pad works seam-

lessly with the Hexapod soft-

ware, and allows programm-

able step sizes of 1 μm to

500 μm (linear) and 0.00

1to

0.5deg (angular) per step.

External positio

ning commands

(via the computer interface) can

be intermixed with manual

positioning input without loss

of the true position, because

both inputs operate on the

same position registers of the

Hexapod controller. The control

pad comes with a 3 m cable. A

3 m extension cable is available

as part number C-815.MC6.

Technical Data

Model F-206.iiU, F-206.VVU Optical Metrology Boards

Optical power range 5 nW – 10 mW

Analog input voltage range 0 – 10 V

A/D resolution 16-bit

Sample rate 10 kHz

Bandwidth 300 Hz (optical input), 10 kHz (electrical input)

Max. sensitivity at: 880 nm (visible, F-206.VVU); 1550 nm (IR range, F-206.iiU)

40% sensitivity at: 480 / 1040 nm (visible, F-206.VVU); 850 / 1680 nm (IR range, F-206.iiU)

More Options see F-311

PIMotion&Vision™ System, F-

361 Optical Power Meter and F-

603 Fiber, Objective and

Waveguide Holders. (www.pi.ws)

F-206.NCU Rapid NanoAlign the P-611.3SF XYZ piezo-drive

Upgrade NanoCube

(see p. 2-52) and

the E-760 controller board (see

For applications where align-

p. 2-138), which is installed in

ment with nanometer-range

the F-206 controller.

resolution is required, or where

rapid mapping of the entire

cross-section of a component

in as short a time as possible

is desired, the F-206.NCU

Rapid NanoAlign upgrade is

recommended. It consists of

F-206.NCU Rapid NanoAlign Upgrade consists of the P-611 NanoCube

piezo nanopositioner and the E-760 controller card

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Axis 850 User Manual Page 10

Comments to this Manuals

Related products and manuals for Servers Axis 850