Axis T8125 Installation Guide download pdf (Page 7)

AXIS T8125 AC 24 V Midspan 60 W Page 7

ENGLISH

AXIS T8125 AC 24 V Midspan 60 W

Installation Guide

Safety Information

AC Power inlet set:

• The power connector supplied with the AXIS T8125 has 2

terminals; LINE (L) and NEUTRAL (N). See Figure 2.

• The power inlet cables must be rated for a minimum current

capacity of 6 amps (12 AWG for each terminal or 2X16 AWG for

each terminal).

• Before connecting power inlet cables to the connector terminals,

verify that the power source is turned OFF.

• Only for improved EMI performance, connect chassis ground

connection to "Earth Ground" connection at the working area.

Note: There is no safety hazard when the chassis ground

connection is not connected to the “Earth Ground”.

• The 24 V AC power source must be near the AXIS T8125 and easily

accessible. To remove AC power from the AXIS T8125, disconnect

the 24 V AC power inlet from either the 24 V AC power source or

the AXIS T8125 power connector.

• The AXIS T8125 DATA IN and DATA & POWER OUT interfaces are

qualified as SELV (Safety Extra-Low Voltage) circuits according to

IEC 60950-1. These interfaces can only be connected to SELV

interfaces on other equipment.

Note: The AXIS T8125 "DATA IN" and "DATA & POWER OUT" ports

are shielded RJ45 data sockets. They cannot be used as

Plain Old Telephone Service (POTS) sockets. Only RJ45 data

connectors may be connected to these sockets.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Axis T8125 Installation Guide Page 7