Axis 7100 Specifications download pdf (Page 18)

Greasing Procedures

Advanced Dicing Technologies Ltd.

3.4-4

b. From the Setup & Diagnostics tree, select saw > Dicer >

Axes > X.

c. In the lower right pane, click Init to initialize the axis, then click

Toggle Self Test. The X Axis begins moving automatically

between its two limits. Allow the X Axis to continue moving for

one minute, then click Toggle Self Test again to turn off the

self-test.

3.4.2.1 Removing the Old Grease from the X Axis

On a quarterly basis, the old grease should be removed from X Axis before

applying new grease.

To Remove Old Grease from the X Axis:

1 Open the Front Door of the System to reveal the X Axis Leadscrew.

2 Remove the old grease from the Leadscrew using waste paper.

3 Grease the X Axis, as described in section 3.4.2.

3.4.3 Greasing the Y and Z Axes

Grease the Y and Z Axes simultaneously, by performing the following

procedure.

To Grease the Y and Z Axes:

1 Remove the Maintenance Panel.

1 X Axis Grease

Nipple

2 Leadscrew

Figure 3-4: Left X Leadscrew and Grease Nipple

Note: On a quarterly basis, remove the old grease before applying the new

grease, as described in section 3.4.2.

1 2 ... 13 14 15 16 17 18 19 20

No comments

Axis 7100 Specifications Page 18