Axis 2110 User's Guide download pdf (Page 13)

AXIS 2110 User’s Manual Other Methods of Setting the IP Ad-

Other Methods of Setting the IP Address

In addition to the ARP command described earlier, you can set the IP address using an

appropriate method for your operating system from the table below:

Important!

Using the AXIS IP Installer

The AXIS IP Installer is a Windows 95/98 & NT/2000 program that is ideal for setting the

IP addresses for multiple Axis’ networking products on your network. Also allowing you to

conveniently access the home Web page of any Axis ThinServer device connected to your

network, this freely distributed software is available for download from the Axis Website at

www.axis.com.

Installing the AXIS IP Installer:

1. Download the latest AXIS IP Installer software onto your desktop and run the

Setup_IPInstaller.exe program to start the installation.

2. The AXIS IP Installer - Setup dialog is displayed on the screen.

3. Follow the instructions as they appear on the screen.

4. Click Finish to complete the installation.

Ethernet Address: The AXIS 2110 is pre-configured with a unique Ethernet Address based upon the serial

number printed on the label on the underside of the unit; where the serial number typically follows the

format 00-40-8c-xx-yy-zz. You must know the Ethernet address to complete the installation.

Method Operating Systems Refer to...

AXIS IP Installer Windows 95/98 and

NT/2000

Using the AXIS IP Installer, on page 13.

DHCP Most DHCP, on page 14.

BOOTP

Requiring a BOOTP daemon on your system, this

method operates over the entire network. A

request to an active daemon initiates a search of

the boot table to find an entry matching the unit’s

Ethernet address. The daemon downloads the IP

address to the device if a match is found.

UNIX Using BOOTP in UNIX, on page 15.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 58 59

No comments

Axis 2110 User's Guide Page 13