Axis 2110 User's Guide download pdf (Page 46)

Troubleshooting AXIS 2110 User’s Manual

No access via the Null

Modem Cable.

Incorrect modem/dial-up

settings.

Check the settings, especially the ports and the communication

speed.

Incorrect use of the cable. The null modem cable is not intended for use as a serial connection

for the AXIS 2110, i.e. it cannot be used to run the AXIS 2110 as a

"PC camera".

The Power indicator is not

constantly lit.

Faulty power supply. Verify that you are using an AXIS PS-D power supply.

The Network indicator

displays red.

Faulty cabling. To verify that the cables are functional, PING the address of a

known unit on your network.

If the cabling is OK and your network is reachable, you should

receive a reply similar to this:

...bytes = 32 time = 2 ms,

The Active and Network

indicators are flashing every

0.5 seconds.

Hardware failure. Contact your Axis dealer.

Your AXIS 2110 works

locally, but not externally.

Firewall protection Check the Internet firewall with your system administrator.

Default routers required Check if you need to configure the default router settings.

The Internet site is too

heavily loaded.

Configure the AXIS 2110 to upload your video images to an FTP

server or an ISP.

No image using Refresh

and/or slow updating of

images.

Requests for images of

varying size and resolution

place a greater demand on

the available file space

within the AXIS 2110.

Ensure that all the clients accessing the images are using the same

image resolution and compression.

For large numbers of clients, configure the AXIS 2110 to upload

your images to an FTP server or an ISP.

A series of broad vertical

white lines appears across

the image.

The CCD sensor becomes

overloaded when the light is

too bright. This can happen

e.g. with sunlight reflexes.

Althought the AXIS 2110 is suitable for outdoor use, direct

exposure to extreme sunlight or halogen light may nonetheless

cause serious damage to the CCD sensor. Reposition your AXIS

2110 in a more shaded location immediately.

Note: damage caused to the AXIS 2110 through over-exposure to

direct sunlight or halogen light is not covered under the product

warranty.

Bad focus. Focus has not been correctly

adjusted.

Referring to the on-line help, adjust the White Balance setting and

then try resetting the camera focus again using the Focus

Assistant, as described in Lenses and Focusing, on page 39.

No adaptor fitted with your

C-type lens.

If you have previously replaced the supplied CS-type lens, you may

have inadvertently installed a C-type lens without first fitting the

required adaptor. See also page 42.

Symptoms Possible causes Remedial actions

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 58 59

Comments to this Manuals

No comments

Axis 2110 User's Guide Page 46

Comments to this Manuals

Related products and manuals for Webcams Axis 2110