Axis 950 User Manual download pdf (Page 9)

Section 2: Basic Installation

AXIS 850/950 User’s Manual 9



Installing the Internal CD-ROM Drive (AXIS 851 and AXIS 951)

The AXIS 851 and AXIS 951 CD-ROM servers are delivered without

CD-ROM drives. If a drive is not already installed by your distributor,

any standard SCSI CD-ROM drive can be installed using the

following steps:

Before you begin:

• Make sure that the power supply is marked with the correct mains

voltage.

• Make sure the power is not connected to the CD-ROM server.

1. Set the SCSI address of the CD-ROM drive you are installing.

SCSI addresses 0 through 6 may be used. We suggest using SCSI

address 0 for the internal drive. See the CD-ROM drive

documentation for instructions on how to set the address.

2. Activate the CD-ROM drive SCSI termination.

See also “SCSI

Devices and Termination” on page 12. For instructions, see the

CD-ROM drive documentation.

3. Connect the SCSI cable and the power cable from the Axis

CD-ROM server to the CD-ROM drive.

4. Slide the CD-ROM drive into the CD-ROM server cabinet.

See figure below.

5. Fix the drive from underneath with the four screws supplied.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 68 69

No comments

Axis 950 User Manual Page 9