Axis Q1922-E User Manual download pdf (Page 8)

AXIS Q19 Series - Product overview

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports PoE (Power over Ethernet, class 3).

Note:

Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded

network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or

similar shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly

grounded. Electromagnetic Compatibility (EMC) for regulatory requirements.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono s

ignal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level), can be connected to a public address (PA) system or an active

speaker with a built-in amplifier. A pair of headphones can also be connected. A stereo connector must be used for audio out.

SD memory card slot - A standard or high capacity SD card (not included) can be

used for local recording with removable

storage.

Note:

Bef

ore removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to

Setup > Systems Options > Storage > SD Card and click Unmount.

Window heater connector - 3-pin terminal block for connection of the

AXIS Q1910-E/Q1921-E/Q1922-E window heater.

Serial number label - Part number (P/N) and Serial number (S/N). The serial number may be required during installation.

Power connector - 3-pin terminal block for power input. Use a limited power source, su

ch as a mains adaptor, which rated

power output does not exceed either 100 W or 5 A. If the Axis product's input voltage is less than 20 V, the current from the

mains adaptor shall still be limited to ≤ 5 A. If the mains adaptor has a higher output voltage than 20 V, its power output shall

still be limited to ≤ 100 W.

AXIS Q1910 8-20 V DC, max 10 W 20-24 V AC, max 15 VA 50/60 Hz

AXIS Q1910-E 8-20 V DC, max 13 W 11-15 V AC, max 18 VA 50/60 Hz

AXIS Q1921 8-20 V DC, max 7 W 20-24 V AC, max 13 VA 50/60 Hz

AXIS Q1921-E 8-20 V DC, max 12 W 11-15 V AC,, max 18 VA 50/60 Hz

AXIS Q1922 8-20 V DC, max 9 W 20-24 V AC, max 14 VA 50/60 Hz

AXIS Q1922-E 8-20 V DC, max 13 W 20-24 V AC, max 20 VA 50/60 Hz

Caution!

Incorrect connection of the wires could cause damage to the camera.

Model DC power input AC power input

DC power input

AC power input

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 62 63

No comments

Axis Q1922-E User Manual Page 8