Axis P3367-VE User Manual download pdf (Page 5)

AXIS P3367–VE Fixed Dome Network Camera

Hardware overview

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet ( PoE). A shielded network cable (STP) must be

used to protect the product against power surges.

Audio in (pink) - 3.5 mm input for a m ono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker

with a built-in a mpliﬁer. A stereo connector must be used for the audio out.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with remo vable storage. For

instructions on how to insert and remove an SD card, please refer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup

>SystemOptions>Storage>SDCardand click Unmount.

Control button - The control button is used for:

• ConnectingtoanAXISVideoHostingSystemservice.Seepage 37. To connect, press and hold the button for about 1

second until the Status LED ﬂashes green.

• Connecting to AXIS Internet Dynamic DNS Service. See page 37. To connect, press and hold the button for about 3

seconds.

• Resetting the product to factory default settings. See page 43.

I/O connector

Note

For technical speciﬁcations, see page 50.

I/O terminal connector - Use in applicat ions for e.g. motion detection, event triggering, time lapse recording and alarm notiﬁcations.

In addition to an auxiliary power and a GND pin, the I/O terminal connector provides the interface to:

• Digital output — For connecting external devices such as relays and LEDs. Connected devices can be activated by the

VAPIX® Application Programming Interface, output buttons on the Live View page or by an A ction Rule. The output will

show as active (shown under System Opti

ons > Ports & Devices) if the alarm device is activa ted.

• Digital input — An alarm input for c

onnecting devices that can toggle between an open and closed circuit, for example:

PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input

becomes active (shown under System Options > Ports & Devices).

Function Pin Notes

Speciﬁcations

GND

Ground

3.3 V DC Power

Can be used to p

ower auxili ary equipment.

Note: This pin can only be used as power out.

Max load = 50 mA

1 2 3 4 5 6 7 8 9 10 ... 53 54

No comments

Axis P3367-VE User Manual Page 5