Axis 7100 Installation Guide download pdf (Page 170)

Workpiece Alignment

Advanced Dicing Technologies Ltd.

6.1-8

flashes a score indicating whether the Model has been successfully

found and displaying the index distance.

After the fifth Index jump, the Camera moves to the bottom of the cut

map (80% of the number of cuts defined in that angle) and attempts to

locate the Model again. If the attempt is successful, the System

calculates the remaining Index positions along the selected angle.

Once this is complete, a confirmation box appears asking the User

whether to update the Index and Align Index parameters with the new

values. (The Align Index parameter is the Cut Index for the opposite

angle. For example, the Cut Index defined for Angle

0º is the same

value as the Align Index for Angle 90º.)

19 Click Yes. The new values for the Index and Align Index parameters

are saved to the Recipe.

6.1.2.1.1 Teaching the Index Manually

A Workpiece must contain a minimum of six streets in order for the System

to be taught the Index automatically. If a Workpiece contains fewer than

six streets, or in case the models are not clear or repeatable, the Index

must be taught manually by performing the following procedure:

To Teach the Index Manually:

1 Perform steps 1 to 8, as described in section 6.1.2.1.1.

2 Click Manual in the Teach Index Process dialog box (see Figure 6-7).

3 Click Next. The Camera moves to the top of the Workpiece.

4 Move to an align point on a Street where a cut is required, using the

X/Y-Axis Controls.

5 Click Next to move to the next align point.

6 Repeat steps 4 and 5 for each additional align point, as required. At the

last align point, click Finish. The System calculates the Index and the

Note: If a Model is not found, the System prompts the user to move to the next

Model.

Figure 6-8: Update Parameters Dialog Box

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 423 424

No comments

Axis 7100 Installation Guide Page 170